LED Indications
Three LEDs indicate the status of the device and its components - LINK, Positioning (GNSS) and SCAN.
- LINK Indicates whether the device is connected to the cloud via the mobile network or linked to a mobile device.
- GNSS Indicates whether the GNSS function is active.
- SCAN Shows whether the device is ready to scan for Remote ID signals.
Device States
Possible states are following:
One or more LEDs are blinking yellow
Yellow means that the pulsing component is not ready for scanning. Wait for all three to turn green, meaning the device is ready to scan. In cases of poor signal, move to an area with better coverage..
Component LED blinking red when power button is pressed.
All indicators are green lit
In this state, the device is ready for scanning. Do the short press of the Power Button to start scanning.
In this state, the device is starting or stopping scanning.
Flashing white on all LED indicators
In this state, the device scans Remote ID data in area.
Device detected drone in scanned area. Device also alerts with a sound alarm (when enabled by user).
One or more indicators are pulsing yellow while scanning
One or more indicators are lit red
Restart device
In this state, the device is powering off.
LEDs pulse blue sequentially (first, second, then third) to indicate the charging progress
The number of non-pulsing LEDs shows the current battery charge. E.g 50% charged, 1 solid and 1 pulsing blue LEDs, 100% charged = 3 solid blue LEDs. Battery charge can be briefly checked by short pressing the Power Button once while turned off.
When pressing both action and power button for 10 seconds, countdown to factory reset will be started. To perform factory reset keep pressing both buttons until all leds are off and RGB animation is started.
RGB animation running when performing firmware update or resetting to factory default settings