LED Indications
Please note the LED on the bottom is only available on models manufactured after April 2026. The LED can be found on the bottom of the device, as shown on the picture below.
The LED on the bottom of the device provides immediate, high-level feedback during installation and maintenance. It is designed to save you trips between the rooftop and your laptop by confirming power, network connectivity, and configuration validity at a glance.
LED Behavior Configuration
You can customize how the LED behaves in the web UI settings to match your specific deployment needs:
-
LED ON: The LED runs continuously in all operating states. Ideal for field tests or tripod use.
-
LED OFF: The LED is fully disabled. Best for maximum stealth or security.
-
LED Auto-Off (Default): The LED stays active for 10 minutes after power-up to assist with installation, then turns off to prevent light pollution
EvenEven in Auto-Off or OFF mode, the LED will **. Once the error is cleared, it returns to its configured state.
Brightness Levels
Adjust the visibility based on your environment:
-
Bright (Default): High visibility for daytime installations.
-
Medium: Balanced for general use.
-
Dim: Designed for sensitive environments; visible only at night when standing directly next to the unit.
Device states
Possible states are following:
Device States
Possible states are following:
LED is solid yellow.
Solid yellow indicates that the unit is powered and software services are starting. The device is not ready for operation yet. Please wait for the initialization process to complete, which typically takes a few moments after power-up.
LED is flashing yellow.
Fast blinking yellow means that although the configuration is valid, the unit cannot reach the LTE network or the data endpoint. Please check the following:
- APN settings: Verify they match your carrier's requirements.
- SIM card: Ensure it has an active data plan and the PIN request is disabled.
- Physical connection: Check the Ethernet cable or ensure your firewall isn't blocking communication with the endpoint.
LED is slowly blinking red.
Slow blinking red indicates that the configuration is incomplete or invalid. The device cannot start its services because some parameters are missing or wrong (e.g., incorrect mode, missing data endpoint, or missing SIM card). Please log in to the web UI and fix the configuration.
LED is solid red.
Solid red signals a severe internal fault or hardware failure. This may be caused by a hardware issue or a system watchdog loop. Try to power cycle the unit. If the LED remains solid red after the restart, please contact support.
LED is slowly blinking white.
Slow blinking white means everything is working as expected. The configuration is valid, the device is connected to the network (LTE or Ethernet), the endpoint is reachable, and the unit is actively scanning and forwarding data.
LED is flashing blue.
Fast blinking blue indicates that the device is currently detecting nearby aircraft (drones or low-altitude manned aviation) based on your configured thresholds. This is a real-time activity indicator useful for verifying test flights or local traffic.
LED is flashing magenta.
Fast blinking magenta indicates a critical system process, such as a firmware update or disk encryption. The device will reboot automatically once the process is complete.
Do not disconnect the power during this time to avoid system corruption.